The Solinst Model 102 Water Level Meter is designed to measure groundwater levels, especially in small diameter tubes and piezometers, or where a flexible assembly is needed to get past down hole instrumentation.
Also available from Solinst, are the Model 101 and 101B Water Level Meters, which feature easy-to-read, easily repaired flat tape. (See Model 101 Water Level Meter Data Sheets).
The Model 102 Water Level Meter uses a choice of two small diameter probe designs, attached to a narrow coaxial cable, fitted on a sturdy ergonomically designed reel. A standard 9 volt battery, housed in an easy-access battery drawer, powers the Water Level Meter.
When the probe enters water the electrical circuit is completed, sending a signal back to the reel where a light and clearly audible buzzer are activated. The water level is then determined by taking a reading directly from the cable at the top of the well casing or borehole.
A sensitivity control allows the buzzer to be scaled back or turned off while in cascading water, and ensures a clear signal in both high and low conductivity conditions.
Model 102 Probes are designed for flexibility. The probe tips use a recessed design to minimize false signals in cascading water.
P10: 10 mm dia. x 70 mm long (3/8" x 2.75") stainless steel with 10 stainless steel weights, weighing 174 g (6.14 oz). This probe is ideal for the majority of water level measurement applications. The flexible weight assembly allows easy well access and keeps the cable hanging straight in monitoring wells.
P4: 4 mm dia. x 38 mm long (0.157" x 1.5") stainless steel weighing 10 g (0.35 oz), with no weights. It is ideal for shallow applications and for accessing very narrow diameters, especially the channels of the Solinst CMT System, DrivePoint Piezometers or narrow open tubes.
Manufactured by: Solinst
Model: Solinst 102 Water Level Meter- With New Laser Marked yellow Cable
Probes | Model 102 Probes are designed for flexibility. The PTFE/FEP tip uses a recessed design to minimize false signals in cascading water. |
P4 | 4 mm x 38 mm long (0.157” dia. x 1.5”) stainless steel weighing 10 g (0.35 oz). It is ideal for accessing narrow diameters, especially the channels of a Solinst CMT System. |
P10 | 10 mm x 70 mm long (3/8” dia. x 1.5”) stainless steel with 10 stainless steel weights, weighing 174 g (6.14 oz). This heavier probe assembly is ideal for greater depths. |
Length Options | Solinst Model 102 Water Level Meters are available on reels in the following standard lengths: |
Mini Reel | 25 m / 80 ft |
Small Reel | 30 m / 100 ft 60 m / 200 ft 100 m / 300 ft 150 m / 500 ft 250 m / 750 ft 300 m / 1000 ft |