PRODUCT DISCONTINUED - REPLACED BY THE LUT400, LR560, OR THE RD500 (APPLICATION DEPENDENT)
The Siemens SITRANS LU AO Analog Output Module provides remote analog output for the measurement points of the SITRANS LU10 level monitor.
The operation of the Siemens LU AO is programmed via the SITRANS LU10. The only on-board settings are for output testing and bank selection. The unit has 10 analog outputs (each sharing a negative bus which is isolated from ground).
Manufactured by: Siemens-Milltronics
Model: SITRANS LU AO Analog Output Module (Discontinued)
The SITRANS LU AO Analog Output Module provides remote analog output for the measurement points of the LU10 level monitor.
Mode of Operation | |
Input | |
Communications | Data from SITRANS LU10 |
- Transmission Rate | 4800 bits/s |
- Voltage | ± 20 mA bipolar current loop |
- Polarization | Non-polarized |
- Max. load | 1 receiving unit |
|Output | |
Analog Outputs | 10 analog outputs, programmable from SITRANS LU10 0 or 4 ... 20 mA, isolated |
± 20 mA bipolar current loop | Input and transmission |
- Max. load | 750Ω |
- Resolution | 0.1% |
Rated Operating Conditions | |
Ambient conditions | |
-Ambient temperature for enclosure | -20 ... +50 °C (-5 ... +122 °F) |
- Location | Indoor/outdoor |
- Installation category | II |
- Pollution degree | 4 |
Design | |
Weight | 2 kg (4.4 lbs) |
Material (enclosure) | Polycarbonate |
Degree of protection | Type 4X/NEMA 4X/IP65 |
- Cable connection | 2 copper conductors, twisted, with foil shield/drain wire, 300 V 0.5 ... 0.75 mm² (22 ... 18 AWG) |
- Electrical connection and relay connection | Copper conductor according to local requirements, rated 250 V 5 A |
Power supply | 100/115/200/230 V AC ± 15%, 50/60 Hz, 15 VA |
Displays and controls | 1 LED for display of voltage/ communications state |
Certificates and approvals | CE, FM, CSAUS/C , C-TICK |